Page Comparison

General Lane Mix Preparation

Libraries To ensure an equal distribution of the reads during the sequencing step, libraries should ideally be pooled in an equimolar ratio for multiplexed sequencing. It is important to ensure accurate quantification quantify accurately ication of the individual libraries prior to pooling, as well as for the final library pool (lane mix). To quantify and pool your libraries:

1. Measure the concentration (ng/ul) of each library using either qPCR or fluorescence-based assays (e.g., QuBit Qubit, Thermo Fisher Scientific Inc.). ATTENTION! Nanodrop is not recommended to measure the final concentration of each library as it is not sensitive enough for accurate readings. The concentrations obtained with Bioanalyzer, Agilent Technologies, Inc., and other capillary electrophoresis instrumentsconcentrations should also be confirmed bywith either qPCR

   of

   or fluorescence-based assays.

2. Determine the average library size using microcapillary electrophoresis analysis (e.g., Bioanalyzer, Agilent Technologies, Inc.). Set the range to 160 180 - 1,000 bp to include the whole library size distribution, and to exclude any linker-linker artifacts or overcycling bumps (>1,000 bp). (150 bp when using 6nt i7 single-indexing ~150 - 200bp depending on Linker-linker artifacts in many Lexogen libraries have a size range of 150 - 200 bp, depending on the indexing strategy and the library preparation kit used), or overcycling bumps (>1,000 bp) and the lower cut-off of the library range should be shifted accordingly.

3. Calculate the molarity from the average library size and the concentration (ng/ul) using the following equation: Molarity = (library concentration (ng/μl) x 1,000,000 ) / (660 x average library size (bp))
   

   e.g.,

   Example: average library size: 320bp, Qubit concentration: 1.4ng/ul
   Molarity: (1.4 ng/ul x 1,000,000) / (660 x 320) = 6.63nM
   
   NOTE: A template for molarity calculation is also available for download from our website: https://www.lexogen.com/support-tools/lane-mix-calculation/
   

4. Pool the same amounts for each library (e.g., the same number of femtomoles for each library).
   NOTE: Alternatively, individual libraries can be diluted to a common molarity (e.g., 2nM) and then an equal volume perof each library can be added mixed together for a to produce the final lane mix.

5. After pooling the libraries, the prepared lane mix and any dilutions made for denaturing (e.g., 2 nM), should be reanalyzed to ensure the accuracy of the concentration. This can be performed according to steps 1 and 2 as above.

...